-
-
X-Axis Assembly
-
20x60 V-Slot Profile
-
GT2 Timing Belt (>450mm)
-
M5 Plate Nut (2 Pcs)
-
M5x6 Grub Screw (2 Pcs)
-
-
-
Slide the 20x60 V-Slot profile into the X-Axis Assembly as shown
-
Slide the GT2 belt underneath one of the top X-Axis V-Wheels, over the GT2 Pulley and underneath the other V-wheel as shown
-
-
-
Fix the belt at the end with the M5 Plate Nuts (2 Pcs), M5x6 Grub Screw (2 Pcs) and Pratley Pratlock in the same way as previously
-
Tension the belt and fix the other side
-
Cut the belt flush with the Side Cutter
-
Make sure the X-Carriage can move easily
-
Cancel: I did not complete this guide.
13 other people completed this guide.
2 Comments
I found this stage difficult to adjust for tightness for the slide rail as access to the lugs is hampered by the screw heads of the other wheels - necessitating removal of the rail each time to make small adjustments to the lugs and refeeding rail. Doable but frustrating for me.
Done at last after some missing M5 plate nuts. Thanks to 3d Printing Store for sending through the missing nuts with speed.
