Help
Paul Cronje
@paulcronje
Paul Cronje
| 6,123 | Reputation |
|---|---|
| 46 | Guides |
| Member Since 10/05/2018 | |
| 6,123 | Reputation |
|---|---|
| 46 | Guides |
| Member Since 10/05/2018 | |
Hi Cobus
We are trying to contact you but we do not have your contact details. Will you please send an email to support@3dprintingstore.co.za with your contact details and description of the problem?
Hi there, please see this link for the wiring of the relay which controls the spindle switching. If you still struggle you can contact us at support@3dprintingstore.co.za
19. Connect Spindle Speed Control and Relay
Hi There. please see this link for the Earth cable connection.
21. Mount Electronics Board
Hi Ronnie,
We are aware of the problem, luckily this will not have an effect on the mechanism so you can use it as is. You will just need to adjust the wheels from the opposite sides when adjusting the tightness on the aluminium.
Hi, its to turn the spindle on and off. GRBL 1.1 switched the pins for spindle enable and the Z limit switch pins.
Hi Cobus.
We have updated the instructions, thank you for letting us know. The black cable from the mosfet will go to the 12V ground on the power supply.