-
-
Side cover assembly (2 Pcs)
-
Y-Rail motor assembly (2 Pcs)
-
M5 plate nuts (4 Pcs)
-
M5x6 Grub Screw (4 Pcs)
-
GT2 Timing Belt
-
-
-
Slide the Y-Rail assembly onto the Side plate assembly as shown
-
Feed the GT2 Belt below the V-wheel, over the pulley and below the V-wheel on the other side
-
-
-
Add Pratley Pratlock to the M5x6 grub screw and Insert it into the M5 plate nut
-
Slide the M5 plate nut over the belt into the V-Slot
-
Clamp the end of the belt by screwing down the M5 grub screw with the 2.5mm Allen Key while pulling the end of the belt
-
-
-
Repeat Step 4 for the other side of the belt
-
Pull the belt with the one hand, while fastening the grub screw with the other hand. Else, ask someone else to pull the belt while you tighten the Grub screw.
-
Cut the belt off on both sides with a side cutter so that it is flush with the V-Slot profile
-
The off cut of the belt will be used later on
-
-
-
Repeat steps 3 to 5 for the other side as well
-
Check if the pulleys on the motor shafts are inline with the GT2 belt
-
Use a brush to dust off aluminium swarf in the extrusion
Use a brush to dust off aluminium swarf in the extrusion
Cancel: I did not complete this guide.
15 other people completed this guide.
