02. Remove components from CNC machine

Written By: Paul Cronje
  • Comments: 2
  • Favorites: 0
  • Completions: 4

Difficulty

Easy

Steps

5

Time Required

00:03:00

Sections

1

Flags

0

  1. Sharp nose pliers

    • Sharp nose pliers

    • 2.5mm Allen Key

    • 3mm Allen Key

    • 5mm Allen Key

    • Small Flat Screw Driver

    Edit

  2. Undo the 6 M6 Cap screw holding the rear waste board in place

    • Undo the 6 M6 Cap screw holding the rear waste board in place

    • This will loosen the electronics board as well

    • Remove the waste board from the machine

    Edit

  3. Loosen all the wires from the relay

    • Loosen all the wires from the relay

    • Remove the Green, Black & Red wires from the CNC machine. These will not be used.

    Edit

  4. Remove the 4 cap screws mounting the relay Remove the relay and screws This relay and screws will not be used for the laser

    • Remove the 4 cap screws mounting the relay

    • Remove the relay and screws

    • This relay and screws will not be used for the laser

    Edit

  5. Remove the two screws mounting the fan above the electronics Remove the two screws mounting the fan above the electronics

    • Remove the two screws mounting the fan above the electronics

    Edit
Finish Line

4 other people completed this guide.

Author

Paul Cronje

Member since: 10/05/2018

6,123 Reputation

46 Guides authored

2 Comments

Would it be possible to Keep the CnC Parts Connected as well so that I can freely swap between the 2 features without disconnecting the relays each time I want to use a different method?

Jan Hendrik Jacobs - Reply

Good day Paul

I have followed all of your instructions but my Power supply LED light doesn’t want to come on and also the LED of the machine. What could be wrong?

Donne - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 20

All Time: 3,227